The 5 inch Rider-Ericcson hot air pumping engine was designed and built by brothers Brent and Lee Myers. It is nicknamed the \u201cBig Brother\u201d to their brother Dean Myers\u2019 3 inch Rider-Ericcson. It is the largest kit in our line of Riders ranging from 1,2.3 inch and now the 5 inch bore. As far as we know, we are the only one selling castings and prints for the 5 inch engine.<\/p>\n

The casting kit is now available for sale. The kit can be purchased with a machined flywheel and cylinder for a small price. The remaining machining can be done in most home shops.<\/p>\n

The Ericcson style engine is a \u201cbeta\u201d engine, which contains both the power piston and displacer within one cylinder. The cylinder has a hot end within the firebox, and a cold end, surrounded by a water jacket. As the air is heated within the cylinder, the air expands, driving the piston upward. The displacer next moves downward, pushing the air from the hot side into the cool side of the cylinder. The air then contracts, pulling the piston downward. The displacer then moves the air from the cool side to the hot side, the cycle begins again.<\/p>\n

The Rider-Ericcson hot air engine, circa 1880 was used to pump water to the upper floors of the house. An engine was placed in the cellar and a tank in the upper part of the house. The water was pumped from the mains to this tank. This engine introduced the \u201cLuxury of water\u201d to our ancestors. These engines were also used at the well sites\u2026spring, well, cistern or brook.<\/p>\n

The advantages of the Rider-Ericcson were that it was absolutely safe; no steam, practically noiseless; could be used at any time when needed; no licensed or experienced engineer required; simple and durable; could be used in many places where any other device or machine would be objectionable or impossible.<\/p>\n

General specifications<\/strong><\/h4>\n

5 inch diameter cylinder bore<\/p>\n

47 \u00bd inches high (to top of flywheel)<\/p>\n

34 inches long<\/p>\n

17 inches deep<\/p>\n

20 \u00bd inches flywheel<\/p>\n

Aluminum castings<\/p>\n

Call for pricing and shipping.<\/p>\n

Hope you have as much FUN building the engine as we did!<\/p>\n","protected":false},"excerpt":{"rendered":"

The 5 inch Rider-Ericcson hot air pumping engine was designed and built by brothers Brent and Lee Myers. It is nicknamed the \u201cBig Brother\u201d to their brother Dean Myers\u2019 3 inch Rider-Ericcson. It is the largest kit in our line of Riders ranging from 1,2.3 inch and now the 5 inch bore. As far as we know, we are the only one selling castings and prints for the 5 inch engine.<\/p>\n","protected":false},"featured_media":455,"comment_status":"open","ping_status":"closed","template":"","meta":{"_et_pb_use_builder":"","_et_pb_old_content":"","_et_gb_content_width":""},"product_cat":[18],"product_tag":[],"class_list":{"0":"post-274","1":"product","2":"type-product","3":"status-publish","4":"has-post-thumbnail","6":"product_cat-hot-air-engines","8":"first","9":"instock","10":"taxable","11":"shipping-taxable","12":"purchasable","13":"product-type-simple"},"yoast_head":"\n